Patient-specific mechanical properties of a flexible multi-body model of the scoliotic spine.

Abstract

The flexibility of the scoliotic spine is an important biomechanical parameter to take into account in the planning of surgical instrumentation. The objective of the paper was to develop a method to characterise in vivo the mechanical properties of the scoliotic spine using a flexible multi-body model. Vertebrae were represented as rigid bodies, and intervertebral elements were defined at every level using a spherical joint and three torsion springs. The initial mechanical properties of motion segments were defined from in vitro experimental data reported in the literature. They were adjusted using an optimisation algorithm to reduce the discrepancy between the simulated and the measured Ferguson angles in lateral bending of three spine segments (major or compensatory left thoracic, right thoracic and left lumbar scoliosis curves). The flexural rigidity of the spine segments was defined in three categories (flexible, nominal, rigid) according to the estimated mechanical factors (alpha). This approach was applied with ten scoliotic patients undergoing spinal correction. Personalisation of the model resulted in an increase of the initial flexural rigidity for seven of the ten lumbar segments (1.38 < or = alpha < or = 10.0) and four of the ten right thoracic segments (1.74 < or = alpha < or = 5.18). The adjustment of the mechanical parameters based on the lateral bending tests improved the model's ability to predict the spine shape change described by the Ferguson angles by up to 50%. The largest differences after personalisation were for the left lumbar segments in left bending (4 degrees +/- 3 degrees). The in vivo identification of the mechanical properties of the scoliotic spine will improve the ability of biomechanical models adequately to predict the surgical correction, which should help clinicians in the planning of surgical instrumentation manoeuvres.