Abstract

In order to analyses the numerical analysis, parameters are very important in the mathematical modelling work. The correspondence output between mathematical modelling and real system is depending on the given parameters. In this paper, estimation and calibration method of brushless DC (BLDC) motor parameters that used in Electric Powered Wheelchair (EPW) through experimental and simulation comparison are proposed. The setup of experiment consists of in-wheel BLDC motor with a driver, 36-volt battery, Arduino microcontroller, speed sensor and current measurement tool. Firstly, the initial parameters of motor are estimated by using related equation and fitting curve method. Then, initial estimated parameters are simulated in EPW modelling. Finally, parameters of the BLDC motor are calibrated according to output speed of modelling and real DC motor using Matlab-Parameter Estimation tool. Result of error shows that the modelling and real EPW output speed is 2.7% after calibration. In conclusion, the calibrated parameters verified to use in modelling and for the further work in designing the control for the EPW.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.