Abstract
The three-dimensional parameterized model of the planetary reducer was established on the platform of Pro/E. Especially, the parameterized gear model was built through transforming the accurate equations of the involute and the tooth root transition curve into the expressions that can be identified by the Pro/E. Therefore, the accuracy of the model is relatively high and the method used in the paper can eliminate tooth interference effectively. Then, the three-dimensional assembly model for planetary reducer was obtained through the Virtual Assembly Technique and the Assembly Module in Pro/E. In brief, the method used in the paper has supplied a relatively accurate model for the dynamic analysis. At the same time, it can reduce dramatically research cycle and cost, and has supplied an effective development approach for the planetary reducer.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
