Oxidation of Ethyne and But-2-yne. 2. Master Equation Simulations

Abstract

The aim of this study is to improve understanding of the tropospheric oxidation of ethyne (acetylene, C2H2) and but-2-yne, which takes place in the presence of HO and O2. The details of the potential energy hypersurface have been discussed in a previous article [Maranzana et al., J. Phys. Chem. A 2008, 112, XXXX]. For both molecules, the initial addition of HO radical to the triple bond is followed by addition of O2 to form peroxyl radicals. In both reaction systems, the peroxyl radicals take two isomeric forms, E1 and E2 for ethyne and e1 and e2 for but-2-yne. Energy transfer parameters (alpha = 250 cm-1) for the ethyne system were obtained by simulating laboratory data for N2 buffer gas, where O2 was not present. In simulations of C2H2 + HO when O2 is present, E1 reacts completely and E2 reacts almost completely, before thermalization. Radical E1 produces formic acid ( approximately 44%) and E2 gives glyoxal ( approximately 53%), in quite good agreement with experiments. For but-2-yne, pressure-dependent laboratory data are too scarce to obtain energy transfer parameters directly, so simulations were carried out for a range of values: alpha = 200-900 cm-1. Excellent agreement with the available experimental yields at atmospheric pressure was obtained with alpha = 900 cm-1. Two reaction channels are responsible for acetic acid formation, but one is clearly dominant. Biacetyl is produced by reactions of e1 and, to a minor extent, e2. The peroxyl radical e2 leads to less than 8% of all products. Vinoxyl radical (which has been reported in experiments involving C2H2 + HO) and products of its reactions are predicted to be negligible under atmospheric conditions.