Oxidation of a quaternary two-phase Cu–40Ni–17.5Cr–2.5Al alloy at 973–1073 K in 101 kPa O 2

Abstract

Oxidation of a quaternary two-phase Cu–40Ni–17.5Cr–2.5Al (at.%) alloy was investigated at 973–1073 K in 101 kPa O 2. The alloy is composed of two phases. One light phase with lower Cr content forms the matrix of the alloy, and the other medium gray phase richer in Cr is presented in the form of continuous islands. At 973 and 1073 K, the kinetic curves for the present alloy deviate evidently from the parabolic rate law. They show a large mass gain in initial stage, and then their oxidation rates decrease evidently with time until they become very small up to 24 h. Cross sectional morphologies show the present alloy is able to form continuous external scales of chromia over the alloy surface with a gradual decrease in the oxidation rate. However, the previous studies showed that a ternary two-phase Cu–40Ni–20Cr alloy is unable to form protective external scales of chromia over the alloy surface, but is able to form a thin and very irregularly continuous layer of chromia at the top of the mixed internal oxidation region. Therefore, substituting Cr in Cu–40Ni–20Cr alloy with 2.5 at.% Al is able to decrease the critical content required to form Cr oxide and help to form continuous external scales of chromia under lower Cr content in two-phase alloys.