Optimizing the Rutherford Backscattering Spectrometry setup in a nuclear microprobe

Abstract

Rutherford Backscattering Spectrometry (RBS) as one of the standard techniques of ion beam analysis for non-destructive quantification of film thicknesses and elemental concentrations, in general requires a good mass separation and energy resolution. In nuclear microprobes large solid angles of detection of ∼100msr are necessary to compensate for the comparably low beam current. However, under these conditions geometrical straggling effects cannot be neglected anymore. Therefore, in order to optimize the RBS detection setup, the geometrical straggling was calculated for circular detectors and the noise contributions to the signal generation and amplification analyzed. The analysis shows that an annular RBS detector should be used directly connected to a dedicated in-vacuum preamplifier. In this way, as is demonstrated in this study with preamplifiers based on an Amptek A250 in a very compact, reliable and low-cost package, excellent energy resolutions of (10.6±0.2)keV FWHM can be achieved in 2.29MeV proton RBS for a 300mm2 Canberra PIPS detector mounted under 86msr solid angle. For smaller detectors even better energy resolutions are obtained, i.e. (5.1±0.2)keV for a 50mm2 Canberra PIPS and (5.8±0.2)keV for a Hamamatsu S1223-01 PIN-photodiode detector for 2.29MeV proton RBS and Scanning Transmission Ion Microscopy, respectively.