Abstract
The helical compression spring is calculated in the STAS 7067 standard based on the wire twist tension and considering the type of deformation, fatigue loading and vibration and buckling effect. To avoid recalculation of the values of already calculated parameters, the proposed calculation method uses the same formulas from STAS, but sets out a set of restrictions that must be observed in the design stages. To optimize design, start with material selection, set minimum and maximum forces, also the type of deformation as well as the admissible dimensions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
