Abstract
Electrical discharge machining (EDM) is one of the importantly non-traditional processing technologies employed for ceramics’ surface processing. Modeling and optimization of the EDM process are essentially applied to find and obtain the optimal values of the responses for materials having smaller surface roughness, higher removing rate of materials, lower electrode wear rate. In this study, the Grey-Taguchi system with AHP weighting was applied in order to optimize the multi-responses of the EDM processing for ceramics. When the EDM processing was used in the ZrO2 ceramics for adhesive metal foils, the multi-response gray relational grade for the optimal level of machining parameter was 0.2685, which was higher than those using the initial experimental conditions. This study has proven that using the Grey-Taguchi system method with AHP weighting to find a model with a highly efficient standard for optimizing differently advanced machining processes is profitable.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
