Abstract
The photo-Fenton oxidation treatment combined with a coagulation/flocculation process was investigated for removal of chemical oxygen demand (COD) from a refractory petroleum refinery wastewater. Scrap iron shavings were used as the catalyst source. A response surface methodology (RSM) with a cubic IV optimal design was employed for optimizing the treatment process. Kinetic studies showed that the proposed process could be described by a two-stage, second-order reaction model. Experiments showed that precipitation of iron ions can be utilized as a post-oxidation coagulation stage to improve the overall treatment efficiency. More than 96.9% of the COD removal was achieved under optimal conditions, with a post-oxidation coagulation stage accounting for about 30% of the removal, thus confirming the collaborative role of oxidation and coagulation in the overall treatment. A low-velocity gradient of 8.0 s−1 for a short mixing time of 10 min resulted in optimum post-oxidation coagulation. Comparison of photo-Fenton oxidation to a standard Fenton reaction in the same wastewater showed more rapid COD removal for photo-Fenton, with an initial second-order rate constant of 4.0 × 10−4 L mg−1 min−1 compared to the Fenton reaction’s overall second-order rate constant of 7.0 × 10−5 L mg−1 min−1.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
