Optimization of Co-Injection Desulfurization of Vanadium Bearing Hot Metal

Abstract

The desulphurization process parameters of vanadium bearing hot metal were optimized. It is found that it has the best desulfurization effect in 100t hot metal ladle, when the lance position is 280mm, the ratio of lime to Mg is 3:1, and the Mg injection rate is 9kg/min. The Si and Ti content of hot metal can increase the activity of S. With the increase of Si and Ti content of hot metal, the final sulfur content has a reduction trend. When the content of Si and Ti is lower than 0.35%, the final sulfur content of hot metal increases, and the hit rate decreases. The effect of hot metal temperature on desulfurization end point hit rate is obvious. When the hot metal temperature is between 1300~1320°C, the hit rate of desulfurization end point is higher. When the temperature is below 1300°C or above 1320°C, the sulfur content increases. After optimization of process parameters, the Mg and lime consumption per ton of hot iron are reduced by 0.11kg and 0.54kg, respectively, with the average hit rate of desulfurization end point increased by 22.6% and 10.7%, respectively.