Abstract
The compression induced by the assembly of proton-exchange membrane (PEM) fuel cells causes partial deformation of the gas-diffusion layers (GDLs) and affects the characteristics of the porous media and, consequently, influences the performance of PEM fuel cells. The objective of the present study is: (1) to develop a three-dimensional model to investigate the effect of assembly clamping pressure on the GDL properties and thus on the performance of PEM fuel cells, and (2) to determine the optimum clamping pressures when the cell is operated under different operating voltages. The optimum clamping pressures under different operating voltages are explored by using a global searching method, namely, the simultaneous perturbation stochastic algorithm (SPSA) method. The simulation results indicate that a clamping pressure of 1 or 1.5 MPa improves the fuel cell performance when the cell is operated under high operating voltages, and causes the cell performance to decrease when it is operated under low-voltage conditions. The optimum clamping pressures increase when the operating voltage increases.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
