Optimization and high-temperature wear characterization of Stellite alloy claddings developed using TIG welding on 56NiCrMoV7 die steel

Abstract

In this study, Stellite 6 and Stellite 12 claddings were deposited on 56NiCrMoV7 hot-worked die steel using the Tungsten Inert Gas (TIG) welding process. Initially, single tracks were deposited using a full factorial design varying two process parameters - current (65, 75, and 85 A) and scan speed (400, 600, and 800 mm/min). The single tracks were then optimized based on dilution rate and microhardness. The optimized parameters were used to develop Stellite 6 and 12 multi-pass clad layers on 56NiCrMoV7. The evaluation of the microstructure of the claddings was done using an optical microscope, XRD, FESEM, EDX, and EBSD. The microstructure of the claddings consists of α-Co matric with M7C3, M23C6, and W2C carbides precipitated along the grain boundaries. Further microhardness and tribological performance were analyzed using Vicker's hardness tester and ball-on-disc tribometer, respectively. Stellite 12 claddings exhibited superior wear resistance and indicated reduced wear volume by 51.3 % at room temperature, 69.2 % at 450 °C, and 32 % at 550 °C compared to the base material and 53.2 % at room temperature, 37.3 % at 450 °C, and 24.1 % at 550 °C compared to Stellite 6 claddings. The KAM mapping showed higher dislocation density for Stellite 12 cladding. The combination of finer grains, higher hardness, and higher dislocation density resulted in higher wear resistance.