Ophiolitic breccias associated with allochthonous oceanic crustal rocks in the East Ligurian Apennines, Italy — a comparison with observations from rifted oceanic ridges

Abstract

In the East Ligurian segment of the North Apennines, eugeosynclinal sequences which contain ophiolitic rocks have been tectonically emplaced onto approximately coeval miogeosynclinal sediments. These allochthonous sequences represent the floor of a Mesozoic ocean which closed during the early Tertiary. The ophiolitic rocks consist of serpentinite, gabbro, pillowed and massive basalts, and breccias derived from these lithologies. They are overlain with depositional contacts by Upper Jurassic-Cretaceous pelagic cherts, limestones, and a shale/limestone sequence. The ophiolitic breccias attain thicknesses up to 100 m and strike lengths up to a few kilometres, and consist largely of unorganized accumulations of sand- to block-sized clasts. Compositions at specific horizons may range from oligomict breccias containing gabbro, basalt, or serpentinite fragments, to polymict breccias consisting of any mixture of these lithologies. Most of the breccias probably represent slow talus accumulations at the base of major submarine fault scarps which have exposed gabbro and serpentinite to submarine erosion. Direct exposure of gabbro and serpentinite on the ocean floor is also indicated by the occurrence of stratigraphically intact contacts between these lithologies and overlying pelagic sediments (generally cherts). The distribution and thickness of the breccias and volcanics, and the distribution of the gabbro and serpentinite, can vary greatly within distances of a few kilometres, thus producing complex heterogeneous sequences consisting of laterally impersistent lithological units. Recent observations and deep drilling of the Mid-Atlantic Ridge and other rifted ridges have revealed occurrences of significant thicknesses of basaltic, serpentinitic, and gabbroic breccias upon and within the volcanic layer of the oceanic crust, as well as the direct submarine exposure of plutonic rocks. It is therefore likely that the East Ligurian sequences represent parts of rifted ridge-generated crust. If so, then the complexity of the East Ligurian sequences suggests that the upper part of rifted ridge-generated crust may in places possess large variations in its stratigraphy over small (<10 km 2) areas. Smooth, non-rifted (fast-spreading) ridges, which have very reduced topography and lack major fault scarps, should form ophiolitic complexes deficient in breccias containing fragments of plutonic igneous rocks. Most large ophiolitic complexes do not contain plutonic rock-bearing breccias, and were therefore probably formed at smooth ridges. The apparently preferential preservation of this type of ophiolitic complex, as opposed to the rifted ridge-type crust in East Liguria, may be related to the less pervasive and less intense fracturing of smooth ridges. This resulted in greater “cohesion” and lateral continuity of smooth ridge-generated crust during later tectonic emplacement into allochthonous positions in orogenic belts.