On the role of martensitic transformation on damage and cracking resistance in TRIP-assisted multiphase steels

Abstract

The damage resistance, fracture toughness and austenite transformation rate in transformation-induced plasticity (TRIP)-assisted multiphase steel sheets were comparatively characterised on two steel grades differing by the volume fractions of the phases (i.e. ferrite, bainite, retained austenite) and by the mechanical stability of retained austenite. The influence of stress triaxiality on austenite transformation kinetics and the coupling between martensitic transformation and damage were investigated using double edge notched (or cracked) plate specimens tested in tension. The map of the distribution of transformation rates measured locally around the notch (or the crack) was compared with the map of the effective plastic strains and stress triaxialities computed by finite element simulations of the tests. The mechanically-activated martensitic transformation was found to progress continuously with plastic straining and to be strongly influenced by stress triaxiality. Fracture resistance was characterised by means of J R curves and CTOD measurements using DENT specimens. The fracture toughness at cracking initiation was found to be lower for the steel with higher tensile strength and ductility. The contrasted influence of the TRIP effect, which improves formability by delaying plastic localisation but reduces fracture toughness at cracking initiation, is shown to result from parameters such as the volume fraction of non-intercritical ferrite phases or the mechanical properties of martensite.