On the Correction of the Melting Curve of the Eutectic Co–C for the Effect of the Thermal Inertia of the Furnace

Abstract

Listen

Translate article

This paper considers the influence of the thermal inertia of the furnace on the shape of the melting curve of the eutectic Co–C. To this end, melting experiments have been performed in a uniform three-zone furnace, with an inherent substantial thermal inertia. The thermal inertia has been quantified by measuring the step-response of the furnace with the sample in its solid state, just below its melting temperature. From the analysis of the effect of the thermal inertia of the furnace, it turned out that during melting the temperature distribution within the furnace, surrounding the crucible, is bound to be in a non-stationary state. This provided the key to properly finalizing the correction to be applied. The shape of the corrected curve differs considerably from that of the curve, as measured, in that the former shows a flatter melting plateau, and a larger curvature on the way down to the solidus point. As regards the liquidus temperature \(T_{\mathrm{liq}}\)—of major interest in the characterization of the transition temperature of high-temperature fixed points—it is demonstrated that the thermal inertia of the furnace shows a kind of self-compensating mechanism. But the effects of the thermal inertia of the furnace on the parameters defining the Scheil fit, involved in the correction procedure, were considerable.