Abstract
The improvement of detection accuracy and reliability of micro delamination defect is restricted by the rough surface. The flat bottom holes (FBHs) are frequently employed as reference targets to evaluate the sensitivity of ultrasonic testing for internal defects. A roughness-modified analytical model for ultrasonic testing of FBHs is established based on the principle of multi-Gaussian beam and phase-screen approximation. The signal of reference reflector is obtained from two-dimensional ultrasonic simulation model. The amplitude changes of echo signals and noises of FBHs with different diameters and depths under rough surfaces are presented. The analyses results indicate that the root-mean-square (rms) height plays a dominant role in the amplitude change of signals compared with the correlation length. The reflected wave amplitude of FBHs decreases nonlinearly with an increase of roughness whereas the amplitude of noise increases slightly. Subsequently, a method is proposed further combining the noise amplitude acquired from numerical simulation and the echo signal amplitude obtained by the analytical model, which is to predict and estimate the detection accuracy of internal defects under different surface roughness. The parallel experiments are performed on several samples with different roughness to validate the evaluation method.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.