Abstract

We have much difficulty to control critical dimension (CD) uniformity for contact layer by optical proximity effect correction (OPC) from 65nm node and below. High mask error enhancement factor (MEEF) in contact layer causes much influence to surrounding layout pattern edges, resulting in long turn-around-time (TAT) from numerous iterations. Methods using nominal OPC cause CD uniformity to get worse depending on pattern layout because MEEF is not considered. Some solutions to this problem may be to calculate MEEF at each pattern edge in order to OPC, and then decide final correction value by using the weight of this MEEF, but additional calculation causes more TAT. We have developed a new OPC method that could optimize pattern layout for contact layer with short TAT because no calculation of each MEEF is necessary. We used our new OPC method to 65nm node LSI. With this method, we were able to control CD uniformity and get good results with no hotspots. Our new OPC method is much useful to OPC for 65nm node and below.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.