Abstract
The neutron wavelength resolution, Bragg-edge measurement ability and future prospects regarding the neutron count rate were investigated at AISTANS. The wavelength resolution evaluated by Bragg-edge analysis using an iron powder sample is in reasonably good agreement with calculations at neutron wavelengths of 0.2–0.3 nm. Bragg-edge imaging was also performed on a steel plate sample with distinct regions of BCC and FCC crystallinity, and the different crystal structures were successfully discriminated. In addition, an aluminum sample containing a friction stir spot welding region was also measured and the 200 and 111 Bragg-edges at the two joining areas were observed. However, it was hard to characterize the difference in texture between the two areas. The neutron counting rate for Bragg-edge imaging is expected to increase by approximately a factor 50 in the near future thanks to the planned improvements of the electron beam power and the detection efficiency of the neutron detector.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.