Abstract

Stress analysis of bridge abutment teeth having cemented dowels was conducted using a two-dimensional finite element method. The results obtained are as follows: 1. In fixed-fixed bridges, compressive stress was found concentrated within the dowel, on the mesial side of the dowel apex, and in the distocervical part of the crown. 2. In cantilever bridges, tensile stress was found concentrated in the disto-occlusal and mesiocervical parts of the crown, and along the mesial sides of the root and the dowel. Compressive stress was concentrated in the distocervical part of the crown, along the distal sides of the root and dowel, and on the mesial side of the dowel apex. 3. In comparison with fixed-fixed bridges, stresses were significantly greater in cantilever bridges in the abutment teeth, the dowel, and crown margins. 4. In both fixed and cantilever bridges, stresses increased in relation to the length of the span. The rate of increase was less, however, in fixed-fixed than cantilever bridges.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.