Molecular Weight of Chitosan Influences Antimicrobial Activity in Oil-in-Water Emulsions

Abstract

The objective of this study was to evaluate the antimicrobial efficiency of chitosans in oil-in-water emulsions. Model emulsions were prepared with 20% corn oil, 1.5% Tween 20, 1.5% Trypticase soy broth, 0.58% acetic acid, and chitosan polysaccharide or chitosan oligosaccharide in concentrations of 0, 0.1, 0.2, 0.5, and 0.7%. A control containing HCl was included to determine the role of acetic acid in the overall antibacterial activity. The pH of samples and controls was adjusted to 4.5. Emulsions were inoculated with Listeria monocytogenes (strains Scott A and 310) or Salmonella Typhimurium DT104 (strains 2486 and 2576) at a level of 107 CFU/ml. Inoculated emulsions were incubated at 10 and 25° C for 4 days and analyzed for bacterial count every 24 h. Both tested Salmonella strains were more susceptible to acetic acid than Listeria. However, L. monocytogenes was more affected by chitosan than either Salmonella strain. During the storage at 25° C, initial inoculum in the emulsions with 0.58% acetic acid and 0.1% chitosan polysaccharide was reduced to below the detection limits after 24, 48, 72, or 96 h for L. monocytogenes 310, Salmonella Typhimurium DT104 2576, Salmonella Typhimurium DT104 2486, or L. monocytogenes Scott A, respectively. Chitosan oligosaccharide was less effective against all tested bacteria and showed a concentration-dependent effect. The antimicrobial efficacy of chitosan was reduced at 10° C, and reduction of microbial loads was delayed for approximately 24 h compared with 25° C. Results suggest that addition of 0.1% chitosan polysaccharidewould be sufficient to ensure the microbial safety of oil-in-water emulsions regardless of storage temperature.