Abstract
In this work, chemical compounds of graphene oxide (GO) and amine molecules as spacers were synthesized by one-step hydrothermal reactions. The products of the reactions, referred to as rGO-Spacers samples, were fabricated into electrodes for supercapacitors. By engineering the molecular structures of the spacers, the specific capacitance (Cs) of the rGO-Spacers can reach up to 612F/g at 2mV/s in cyclic voltammetry (CV) measurement, 597F/g at 0.5A/g and 512F/g at 10A/g in galvanostatic charge–discharge measurement using two-electrode setup with 1M sulfuric acid aqueous solution at the electrolyte. 97% of the high Cs was retained after 10 000 charge–discharge cycles. In comparison, the control sample without spacers presents a Cs of 194F/g measured in CV measurement under the same conditions. The increased interlayer distance up to 1.9nm between graphene sheets caused by addition of the amine spacers was confirmed by X-ray diffraction. The morphology of rGO-Spacers samples was characterized by scanning electron microscope, transmission electron microscope and atomic force microscope, where crumpled thin sheets were observed. The spacer molecules were found to disperse uniformly on the sheets by energy dispersive spectroscope mapping. Chemical reactions and covalent bonding between GO and the spacers are evidenced by thermogravimetric analysis, X-ray photoelectron spectroscopy (XPS), UV–visible spectroscopy, Fourier-transform infrared spectroscope and Raman spectroscopy. Based on the characterization results, the amide formation reactions and epoxide ring opening reactions between amine spacers and GO are proposed. The weight measurement and the atomic ratio information from XPS further reveal different reactivity of the spacers to GO, which could account for the different Cs of the samples with spacers of different molecular structures. From the results of these comparative studies, the engineering of the molecular structures was found to play a pivotal role in determining the value of Cs. The findings also provide guidance to achieve even higher Cs by optimization of the molecular structures of the spacers, as well as other experimental parameters which can facilitate the reaction between the spacers and GO.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.