Abstract
The influence of alloying (10 wt% Molybdenum) and post deposition treatment (Laser Surface Melting) on the structural characteristics and wear performance of Plasma Transfer Arc deposited M2 hardfacings have been investigated. The nature of matrix and carbides of M2 hardfacing had changed upon Molybdenum addition while the Laser Surface Melting caused structural refinement and a decrease in carbide volume fraction. Despite an increase in hardness, Laser Surface Melting has resulted in reduction in sliding wear resistance against alumina counterface, while the Molybdenum enhanced the wear resistance even with decrease in hardness. This counter intuitive behaviour is attributed to Magnelli oxide containing tribo-oxide layer formation on the worn surface of Molybdenum alloyed hardfacings.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
