Abstract
AbstractElectrolytic model tank experiments to study resistivity and time domain induced polarization (IP) response over layered earth models were initiated primarily to facilitate the understanding of field results. Alternate layers of clay and sand (or clay‐coated sand) with, in some cases, a surficial layer of water were assembled in the tank and resistivity and IP measurements made for a range of electrode spacings using the Wenner configuration. Graphite and silver‐silver chloride electrodes were used as current and potential electrodes respectively.Clay‐coated (3% by weight) sand was found to generate stronger polarization than either clay or sand alone. Apparent chargeability ma was observed to be positive for a nonpolarizable surface layer. For a polarizable surface layer, the sign of IP was controlled by the polarizability, the thickness of the second layer, and the spacing of the electrode spreads. The apparent chargeability ma can theoretically change sign from positive to negative and vice versa with a gradual increase in electrode spacing, and such negative IP effects were obtained in a few observations. A simultaneous decrease in IP and an increase in resistivity, which is a qualitative diagnostic feature for the occurrence of clean freshwater sand aquifers, could also be generated in the model tank experiment.Combined resistivity and IP soundings were carried out near Fredericton Junction and Tracy, New Brunswick, Canada. Field curves are presented along with the model curves for qualitative comparison and understanding of IP behaviour over a layered earth. Twenty‐five out of twenty‐seven soundings show only positive apparent chargeabilities, whereas two show chargeability sign changes (positive/negative/positive). The model study gives reason to believe that surface soils and Quaternary gravel boulder deposits near Fredericton Junction are relatively non‐polarizable.As an auxiliary experiment, sand and clay were taken in different proportions by weight and mixed thoroughly with water in a cement mixer. The mixtures were then compressed with a suitable die and plunger under 3.6 Pa pressure to prepare cylindrical samples of height 18 cm and diameter 15.5 cm. IP measurements were done on the flat faces using the Wenner configuration with a= 2 cm. Chargeability was found to be negative for 100 and 90% clay mixtures. It reached a positive maximum for an 80% clay‐20% sand mixture and then decreased gradually with increasing sand and decreasing clay content.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.