Abstract

Normal, symmetric fracture toughness tests can give high values for the toughness of the joint between the immiscible polymers polystyrene and polymethylmethacrylate. These high values, which are caused by crazes growing away from the interface into the polymer with lower craze resistance, are not a fair characterization of the toughness of the joint. Much lower, and more realistic, toughness values are obtained by the use of an asymmetric test that tends to drive the crack and crazes more along the interface.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.