Mitigating degradation and modulating electronic structure via an epitaxial perovskite protection for Li-rich layered oxides

Abstract

Li-rich layered oxides are highly promising cathode materials for the next-generation lithium-ion batteries due to their extraordinary specific capacity and hence high energy density. However, their practical application is hindered by the structural and surface instabilities as well as sluggish reaction kinetics. Herein, a low-crystallinity perovskite oxide (NdTiO3) is developed to epitaxially conform the surface of a typical Li-rich layered oxide Li1.2Mn0.54Ni0.13Co0.13O2 to overcome these drawbacks. Experimental and computational results confirm that this surface phase not only mitigates structural deformation and interfacial side reactions, but also can modulate the electronic structure of Li2MnO3 for the higher electron conductivity. As a result, the epitaxially-protected cathode material displays much better cycle stability (222.02 mA h g−1 after 200 cycles at 1C compared to 185.06 mA h g−1 for the uncoated one) and excellent rate capability (155.71 mA h g−1 at 5C). A pouch-type full cell using commercial graphite anode demonstrates an energy density (381.38 Wh kg−1 based on the cathode and anode) and a capacity retention of 91.1% after 100 cycles.