Abstract
Abstract Recent research interest in solid oxide fuel cells (SOFCs) has grown towards effective manufacturing processes that are compatible with low-cost materials such as stainless steel structural supports. Suspension plasma spraying is a promising technique that rapidly produces a fully consolidated, thin electrolyte layer with good microstructure control and without any post-deposition heat treatment. In the present study, suspension plasma spraying was used to deposit yttria-stabilized zirconia electrolyte coatings on porous stainless steel substrates using a range of spray conditions. Mechanical properties of the coatings, such as hardness and fracture toughness, were characterized. These properties can affect the durability of SOFC electrolytes, coupled with the thermal stresses generated during operation. Coating toughness and hardness were observed to be dependent on the torch power and stand-off distance during fabrication, which affect coating microstructural features such as porosity, microcracks, and segmentation cracks. The fracture toughness measured using an indentation technique of the coatings produced with a torch power of 133 kW and a stand-off distance of 90 mm was found to be 1.5 ± 0.15 MPa m1/2.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
