Abstract
Future materials for wear resistant components require a combination of excellent mechanical properties such as hardness and toughness, short processing times and good electrical conductivity to facilitate shaping by electro discharge machining (EDM). In this work, the hardness and fracture toughness of t-ZrO2 based electro conductive composites was optimised, while short processing times below 20 minutes using spark plasma sintering were sufficient to obtain near fully dense materials. The influence of powder processing technique using TiC0.5N0.5 as the starting powder and yttria as a stabiliser on the mechanical properties of ZrO2-TiC0.5N0.5-Al2O3 based composites was investigated. Fully dense Y-TZP based composites possessed an excellent toughness of 9.2 MPa.m1/2 and an increased Vickers hardness of 1397 kg/mm².
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
