Abstract
We have investigated the effects of a heating rate in the calcination process on microstructures of YBa2Cu3O7−y (YBCO) precursor and final films. As a result, it was found CuO segregation in the YBCO precursor film, when the precursor was prepared at a rapid heating rate in the calcination. In the case of heating this precursor film in the crystallization process, many large pores and misoriented YBCO crystals tend to remain in the YBCO final film and its IC value deteriorates compared with the case of crystallizing the precursor, which is prepared at the slow heating rate in the calcination. It is important to control the heating rate in the calcination, in order to attain higher JC of the YBCO final films.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.