Abstract

The microstructures and mechanical properties of cast Al-3Li-1.5Cu-0.2Zr alloy during heat treatment were investigated. The results showed that large amounts of secondary phases distributed along grain boundaries in as-cast state, and most of them dissolved into the α-Al matrix after solution treatment. The alloy had a very strong age-hardening response with the peak-hardness that was more than double for the as-quenched. TEM showed much fine δ′ (Al3Li) particles were homogeneously distributed after quenching, and long δ′ phases were observed during ageing. Fine T1 (Al2CuLi) precipitate was visible after ageing for 8h at 175°C, and both its number density and size increased with the increase of ageing time. Apart from δ′ and T1, θ′ (Al2Cu) phases of large aspect ratio were precipitated in the over-aged condition. As the ageing proceeded, the δ′ particles coarsened and the Precipitate-Free Zones (PFZs) developed, resulting in poor ductility and premature failure. The studied alloy was largely strengthened by the δ′ phase during ageing. After ageing at 175°C for 32h, a good mechanical property with ultimate tensile strength (UTS)=382MPa, yield strength (YS)=307MPa and elongation (EL)=2.9% was obtained.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.