Micro/Nanostructure and Tribological Characteristics of Pressureless Sintered Carbon Nanotubes Reinforced Aluminium Matrix Composites

Abstract

This study reports the manufacture, microstructure, and tribological behaviour of carbon nanotube reinforced aluminium composites against pure aluminium. The specimens were fabricated using powder metallurgy method. The nanotubes in weight percentages of 0.5, 1.0, 1.5, and 2.0 were homogeneously dispersed and mechanically alloyed using a high energy ball milling. The milled powders were cold compacted and then isothermally sintered in air. The density of all samples was measured using Archimedes method and all had a relative density between 92.22% and 97.74%. Vickers hardness increased with increasing CNT fraction up to 1.5 wt% and then reduced. The microstructures and surfaces were investigated using high resolution scanning electron microscope (SEM). The tribological tests showed that the CNT reinforced composites displayed lower wear rate and friction coefficient compared to the pure aluminium under mild wear conditions. However, for severe wear conditions, the CNT reinforced composites exhibited higher friction coefficient and wear rate compared to the pure aluminium. It was also found that the friction and wear behaviour of CNT reinforced composites is significantly dependent on the applied load and there is a critical load beyond which CNTs could have adverse impact on the wear resistance of aluminium.