Abstract
AbstractThis paper reports production of 4.5 μm-diameter monodisperse water drops using a micro electro-mechanical system (MEMS)-based 1 MHz 3-Fourier horn ultrasonic nozzle. The required electrical drive voltage for atomization was 6.5 V at 964±1 kHz that is in good agreements with the values obtained by impedance measurement and by the three-dimensional (3-D) simulation using a commercial finite element analysis program. Such small diameter drops with geometrical standard deviation (GSD) as small as 1.2 and 90% inhale-able fine particle fraction (<5.8 μm-diameter) were achieved in ultrasonic atomization for the first time. Therefore, the MEMS-based MHz ultrasonic nozzles should have potential application to targeted delivery of reproducible doses of medicine to the respiratory system.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.