Abstract
High density polyethylene (HDPE) was used as the matrix material for a carbon nanotube (CNT) polymer composites. This combination of composite constituents has not been previously reported in the literature. Multi-wall carbon nanotube (MWNT)/HDPE composite films were fabricated using the melt processing method. The composite films with 0, 1, 3 and 5% nanotube content by weight were analyzed under SEM and TEM to observe nanotube dispersion. The mechanical properties of the films were measured by small punch test. Results show increases in the stiffness, peak load and work to failure for the composite films with increasing MWNT content.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
