Mechanical property of magnesium alloy sheet with hardening deterioration at warm temperatures and its application for failure analysis: Part I - property characterization

Abstract

The mechanical property of a thin AZ31B Mg alloy sheet (with the thickness of 0.5 mm) was characterized for its anisotropy, temperature-dependent hardening (including its deterioration) and strain rate sensitivity based on simple tension test data measured at 100 °C, 150 °C, 200 °C, 250 °C, respectively, in Part I. As for anisotropy, simple tension tests were performed along three (rolling, transverse and in-between) directions to calibrate the Hill1948 yield function. As for temperature-dependent hardening, the common practice is to characterize hardening only up to the uniform elongation limit and to extrapolate the data to cover the range beyond its limit. In this work, hardening as well as its deterioration (or softening) behavior observed beyond the uniform elongation limit was numerically characterized based on the inverse calibration method, in which strain rate sensitivity was also considered. The mechanical properties were confirmed to properly predict failure by strain localization for all the simple tension tests involved in the characterization procedure. Ultimately, the mechanical properties characterized in Part I were applied in Part II to analyze the failure by strain localization in the cross-shaped cup drawing tests developed as the benchmark problem for the NUMISHEET2011 conference [1].