Measurement of the Water Potential of Stored Potato Tubers

Abstract

A method of measuring the water potential of stored potato tubers (Solanum tuberosum L.) was needed to investigate the relationship of bacterial soft rot in tubers to water potential. Pressure chamber measurements, while useful for tubers with functional stolons, cannot be made on stored tubers. Measurements could be made on excised tissue pieces in a hygrometer chamber and with hygrometers implanted into tubers. We report here our evaluation of these hygrometric methods using a comparison with the pressure chamber on tubers harvested with stolons intact.In tubers of high water potential, measurements on excised tissue were as much as 0.5 megapascals lower than the pressure chamber, probably due to turgor-driven expansion of the sample when freed from constraints imposed by surrounding tissue. Good agreement (+/-0.05 megapascals) was found between the implanted hygrometer and the pressure chamber at potentials higher than -0.5 megapascals. At lower water potentials, both hygrometer measurements were higher than the pressure chamber. Respirational heating of the tissue contributed to the increase in the excised tissue samples, but not with the implanted hygrometers because of the hygrometer design. The osmotic pressure balanced the pressure chamber measurement of potential at -0.7 megapascals, but was too small to do so at lower potentials. At most, 25% of this discrepancy can be accounted for by dilution by apoplastic water. We believe that the pressure chamber measurement is too low at low water potentials and that the error is associated with air bubbles in the xylem. At low potentials air emerged from xylem vessels along with sap, and fewer xylem emitted sap as potentials decreased.