Abstract
The article is aimed on material properties evaluation of Ni and NiCr Cold Spray layers by means of proportional small specimens. For the purpose of testing, various cold spray layers were prepared. Spraying with nozzle for inner tube application from two NiCr powders of different particle sizes and from Ni powder of one particle size was applied. In addition, spraying with nozzle type for outer tube applications from same Ni powder was applied too. The evaluation is aimed on mechanical properties and metallographic analysis of cold spray layers as received and after defined heat treatment, comparing small and standard testing specimens. It provide overview of the tensile properties at room temperature and the microstructure of used powders and final cold sprays. Ultimate tensile strength, yield strength, hardness and plastic elongation are evaluated from the mechanical point of view. Metallographic analysis is focused on particle size in powders and splat size in manufactured layers. Porosity of sprayed layers is evaluated on tested specimens and the influence of specimen dimensions is discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
