Abstract

The strength of materials at high strain levels has been determined using the so-called Continuous-Bending-under-Tension (CBT) test. This is a modified tensile test where the specimen is subjected to repetitive bending at the same time. This test enables to create high levels of uniform strain. A wide variety of materials has been tested this way. The strength of the material after CBT testing has been measured in different ways: by secondary tensile tests, by interrupted CBT tests, and directly from the fracture in the CBT test. All methods yield similar results: the strength is largely unaffected by the cyclic pre-deformation and mainly depends on the overall increase in length. Only for multi-phase materials the strength shows a minor influence of CBT test conditions. The hardening follows the extrapolated hardening observed in a conventional tensile test, except for brass. This test method can potentially be used for measuring hardening curves at high strain levels.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.