Abstract
In order to simulate straw cutting process, this paper established a maize straw cutting model with discrete element method (DEM) based on straw cutting experiment. Firstly, maize straw model consisting of several small particles was established by DEM. Then, a straw cutting experiment was conducted and the maximum straw cutting resistance was 199 N for straw with 15 mm diameter. Then, single-factor experiment was conducted to analyze the effect of DEM parameters on straw cutting effect and the max straw cutting resistance Fmax. The normal stiffness between particles and blade (ball-facet-kn) and shear stiffness between particles and blade (ball-facet-ks) were found to be the significant factors affecting Fmax, and the value of the parameters that has no significance was determined. The optimum combination of the significant parameters was 17662 N·m-1 of ball-facet-kn and 52499 N·m-1 of ball-facet-ks. The verification test results showed that the maize straw model was cut off, thus it could simulate the real straw cutting effect, and the relative error of max straw cutting resistance Fmax between the simulation and the experiment was below 9.1%. Thus, it could be concluded that the established maize straw cutting model was accurate and reliable.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
