Magnetophoretic Control of Diamagnetic Particles Inside an Evaporating Droplet.

Abstract

The present study reports the magnetophoresis of diamagnetic particles in an evaporating ferrofluid droplet. Both solid and ring magnet arrangements are used to investigate the effect of magnetic field distribution. The distance of the magnet from the droplet is varied to study the effect of magnetic field strength. The magnetic field distribution is computed using COMSOL multiphysics software. Magnetometer measurements have been carried out to validate the simulation results. The motion of particles and the drying pattern of evaporating ferrofluid droplets are visualized using the confocal microscopy technique. Both bright-field and fluorescence imagings have been carried out to observe the differential deposition of the fluorescent particle (microparticle) and magnetic nanoparticles in the absence and presence of a magnetic field. The velocity of diamagnetic particles as a function of magnetic field distribution and strength has been studied using the micro-PIV technique. In the absence of the magnetic field, a ring-shaped deposition pattern is observed. The mixture of microparticles (diamagnetic) and nanoparticles (magnetic) is deposited between the outer and inner edges of the ring. The diamagnetic particles occupy the inner and outer edges of the ring. Magnetic particles travel toward the higher magnetic field zone and diamagnetic particles move toward the smaller magnetic field zone when a magnetic field is applied by a solid magnet placed over the droplet. This can be attributed to the negative magnetic force originating from the difference between the susceptibility of magnetic and nonmagnetic particles. The negative magnetic force on the microparticle increases as the magnetic field intensity increases, causing the microparticle to convect faster toward the contact line. The deposition behavior can be reversed or suppressed using a ring magnet in place of a solid magnet. In this case, the negative magnetic force is stronger at the contact line region of the droplet and decreases as it approaches the center region of the droplet. The deposition behavior of diamagnetic particle depends on the balance between the Marangoni force and the magnetophoretic force. Overall, the present study demonstrates the capability of the controlled deposition of diamagnetic polystyrene particles by suitable arrangement of the solid and ring magnet.