Abstract
The melt-spun ribbons of Didymium-Fe-Co-Nb-B system alloys were prepared by single roller liquid rapid-quenching method. The effects of composition, wheel velocity and heat treatment on the magnetic properties were investigated. As the result, Didymium 12.5Fe 70.5 Co 10Nb 1B 6 ribbons prepared at a wheel velocity of 20.0 m/s were crystallized by heat treatment, and the optimum heat treatment condition was found to be at 625 °C for 5 min, and then the values of (BH) max and H cJ were 126.1 kJ/m c, 1048.8 kA/m, respectively. The value of (BH) max for the isotropic compression molding Didymium 12.5Fe 70.5CoNb 1B 6 bonded magnet prepared by using the ribbons annealed at 625 °C for 5 min was 91.0 kJ/m c and the density was 6.3 Mg/m c. Irreversible loss of the bonded magnet was −2.34%(at 125 °C). It was found that the vibration brushless motor using Didymium 12.5Fe 70.5Co 10Nb 1B 6 bonded magnet rotor was better than that of using MQP-O bonded magnet rotor in the rotating speed stability for low-voltage area and the vibration force.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
