Abstract
This article presents the examination of cutting performance of a low CBN content cutting tool in the case of hard turning of 100Cr6 hardened bearing steel. One of the indicators of cutting performance is the wear rate, which can be calculated as a ratio of a measurable geometric parameter of a wear form and some technological parameters (cutting time, cutting length or removed material volume). The wear of CBN cutting tools is characterized by the extent of flank wear hence the wear rates related to cutting time and removed material volume are calculated based on the measured flank wear during the cutting experiments. The alteration of wear rates as a function of flank wear and cutting speed was examined.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.