Abstract
We present a new method for the low-cost manufacture of micro fluidic devices from polymers for single use. Within a one-step or two-step process inside a hot embossing press, micro channels are thermoformed into a thin plastic film and welded on to a thicker plastic film or sheet. Sterile, hermetically sealed micro fluidic structures were fabricated from polystyrene for easy opening immediately before use. It even appears to be possible to produce micro fluidic analysis chips from polymers on a coil from which single devices are cut off for use.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.