Low‐alloy TRIP steels: a correlation between mechanical properties and the retained austenite stability

Abstract

In recent years the technology of low‐alloy TRIP steels has considerably advanced. The mechanical properties are characterised by a combination of high yield strength and high uniform elongation as well as enhanced formability. In the present work an effort to correlate mechanical properties with the retained austenite stability was made. Two low‐alloy TRIP steels were investigated. The first of them represents a typical composition of the low‐alloy TRIP steels, while the other one contains aluminum as alloying element. The influence of the heat treatment on the mechanical properties and especially on the amount and stability of the retained austenite was determined. The retained austenite stability was measured with a single specimen technique, in which a tensile specimen was used to determine the MσS temperature with a loading‐unloading procedure. The results showed that there is a strong influence of the stability of the retained austenite on the mechanical properties. Increased stability combined with a high amount of retained austenite, exhibited an increase in both, yield strength and uniform elongation while increased amount of retained austenite with low stability did not show the same good combination of mechanical properties. The results clearly indicate that in order to get the maximum TRIP effect, a good combination of austenite stability and amount is required.