Abstract
Precision forging is a choice for compressor blade fabrication. Pressure and suction surfaces could be forged to yield design requirements but the blade edge could not. A localization for machining blade edge, considering forging deformation and surface continuity, is discussed in this paper. Different from making machining allowance more balance in past researches, minimizing the difference between machined surface and design surface is adopted. Except machining allowance constraint, new constraints about form tolerance and geometry continuity are built up for localization. As a model for generating tool path, the machining surface of the blade edge is determined by adjusting a group of section curves under proposed constraints. At last, a precision forging blade is applied to verify the proposed localization method.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: The International Journal of Advanced Manufacturing Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.