Abstract
Laser brazing processes of aluminum with both single beam and double beam techniques were developed using a new AlZn13Si10Cu4 filler wire which has a lower solidification range comparing to normal AlSi12 filler wire and the base material. Brazing experiments on both bead on plate and flange joints showed that the new wire has a very good wettability on the aluminum samples. Comparing to the AlSi12 wire one needs a lower heat input (in some cases 73% less heat input) for joining the same samples with the new filler wire and reaches a high hardness value in the joint. In addition, brazing with double beam technique showed its potential to increase the joint quality.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.