Abstract

A novel via hole metallization method is presented, where the vias are drilled in polyimide/copper (PI/Cu) flexible printed circuit boards (PCBs) using KrF excimer pulses, and then pre-metallized using a scanned Ar+ laser. In the premetallization step, a thin (20–50 nm) and narrow (2–10 μm) palladium layer is deposited on the polyimide-covered side of the PCB and on the wall of the vias using the laser-induced chemical liquid-phase deposition method. After the pretreatment, the Pd covered holes are immersed into a Cu electroless plating bath. Plated copper vertical and horizontal interconnects are analyzed by optical microscopy, focused ion beam, profilometry and resistivity measurements. The results show that the copper deposits formed on the pre-metallized surface of PCBs have high chemical purity, excellent adhesion and almost bulk conductivity, but, so far, due to unclear reasons, high through hole resistance.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.