Abstract
ABSTRACTThe application of ion beam mixing and ion implantation techniques in the formation of ohmic contacts to n-Hg1-xCdxTe (x = 0.6, 0.7) has been investigated. For experiments in ion beam mixing, an indium layer (15nm thick) on Hg1-xCdxTe wasbombarded with 45keV Te+ ions at doses ranging from 1 × 1013 to 1 × 1016 cm2. Minimum values of specific contact resistance, pc, of 4 × 10-4Ωcm-2 were measured for a dose of 1 × 1016 cm-2 after 200°C annealing; pc was independent of dose in this range. Analysis of the interfaces by Auger depth profile and Rutherford backscattering spectrometry has shown that ion beam mixing produced an enhanced indiffusion of indium. In comparison, samples which were ion implanted with In+ at 50keV prior to metalisation showed a reduction in pc which was strongly dependent on dosage.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
