Abstract
Integrated experimental–modelling studies on microstructural development and kinematics of blown film extrusion of low- and high-density polyethylenes (LDPE and HDPE) films are reported. First, the microstructural evolution along the machine direction of the film line is reported from Raman spectroscopy. The 1418 cm−1 peak associated with wagging of the –CH2 group in the crystalline phase was measured using mobile Raman probes. The changes in take-up ratio, blowup ratio and freeze line height displayed varied levels of influence on the rate of crystallisation. The two polyethylenes develop significantly different extents of crystallinity in the final product form, but higher strain-rates led to faster kinetics and confirmed flow-enhanced crystallisation phenomenon in both polymers. The effect of processing conditions on the development of crystallinity in LDPE and HDPE was consistent with that reported earlier for linear low-density polyethylene (LLDPE), thus confirming the use of Raman spectroscopy as an efficient and reliable analytical technqiue for monitoring microstructure in real time. These results are compared with predictions from a flow-enhanced crystallisation model in a companion paper.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
