Abstract
Due to a combination of high hardness and toughness, resulting in excellent wear resistance, cemented carbides are commonly used as the rock crushing component in rock drilling. The present paper presents a unique study where the very initial stages of deformation and wear of cemented carbide in sliding contact with rock are followed in small incremental steps. After each step, a pre-determined area within the wear mark is characterized using high resolution SEM and EDS. This facilitates analysis of the gradual deformation, material transfer, degradation and wear. The deterioration mechanisms found in this sliding test are similar to those observed in actual rock drilling. Cemented carbide grades with different microstructures show significant differences, where a higher amount of Co and a larger WC grain size both are associated to more wear.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Refractory Metals and Hard Materials
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.