Abstract

Residual stresses are a major factor in the reliable operation of multi-layer thin film structures. These stresses may form due to defect incorporation during deposition, recrystallization, second-phase precipitation, thermal coefficient of expansion (TCE) mismatch, etc., as well as local plastic flow, delamination or cracking. In the literature, residual stresses are usually assumed to be constant in the plane of the film. This assumption is sometimes implicitly made, as in the cases where only two psi-tilts are used in the stress determination with the sin2Ψ analysis.In this paper, we will review the possible causes of heterogeneous stress distributions in thin films and discuss their impact on x-ray stress determination techniques using some new data from W films.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.