Influence of two-stage injection and exhaust gas recirculation on the emissions reduction in an ethanol-blended diesel-fueled four-cylinder diesel engine

Abstract

The purpose of this study is to investigate the effects of two-stage injection and exhaust gas recirculation (EGR) on the spray behavior and exhaust emission characteristics in diesel–ethanol fuel blends fueled four-cylinder diesel engine. The spray behavior is analyzed from the spray development process, spray tip penetration, and spray cone angle, which are obtained from the spray images. The combustion and exhaust emission characteristics are measured from the four-cylinder diesel engine with a common-rail injection system. The experimental results revealed that the increase of the pilot injection amount causes the fast development of the injected pilot spray, and the penetration difference among the main sprays is less than that among the pilot sprays. An increase in the ethanol blending ratio causes an increase in the ignition delay in the pilot combustion, but the main combustion is little influenced by the ethanol blending. The increase in the pilot injection amount shows the reduction effects of NO x emissions when the pilot injection timing is advanced beyond BTDC 20°. The concentration of soot emissions shows a decreasing pattern according to the advance of the pilot injection and the decrease in the pilot injection amount. The CO emissions increase with the advance of the pilot injection timing, the increase in the pilot injection amount, and the ethanol blending ratio. In addition, the increase in the ethanol blending ratio and the advance of the pilot injection timing induce an increase in the HC emissions. The increase in the pilot injection amount induces a slight increase in the HC emissions.